3D Centrifuge Modeling of the Effect of Twin Tunneling to an Existing Pile Group

Authors

  • M. A. Soomro Department of Civil Engineering, Quaid-e-Awam University of Engineering, Science & Technology, Nawabshah, Pakistan
  • M. A. Keerio Civil Engineering Department, Quaid-e-Awam University of Engineering, Science & Technology, Nawabshah, Pakistan
  • M. A. Soomro Department of Civil Engineering, Quaid-e-Awam University of Engineering, Science & Technology, Nawabshah, Pakistan
  • D. K. Bangwar Civil Engineering Department, Quaid-e-Awam University of Engineering, Science & Technology, Nawabshah, Pakistan
Volume: 7 | Issue: 5 | Pages: 2030-2040 | October 2017 | https://doi.org/10.48084/etasr.1393

Abstract

In densely built urban areas, it is inevitable that tunnels will be constructed near existing pile groups. The bearing capacity of a pile group depends on shear stress along the soil-pile interface and normal stress underneath the pile toe while the two would be adversely affected by the unloading process of tunneling. Although extensive studies have been conducted to investigate the effects of tunnel construction on existing single piles, the influence of twin tunnel advancement on an existing pile group is merely reported in the literature. In this study, a series of three-dimensional centrifuge tests were carried out to investigate the response of an existing pile group under working load subjected to twin tunneling at various locations in dry Toyoura sand. In each twin tunneling test, the first tunnel is constructed near the mid-depth of the pile shaft, while the second tunnel is subsequently constructed either next to, below or right underneath the pile toe (Tests G_ST, G_SB and G_SU, respectively). Among the three tests, the 2nd tunnel excavated near the pile toe (Test G_ST) results in the smallest settlement but the largest transverse tilting (0.2%) of pile group. Significant bending moment was induced at the pile head (1.4 times of its bending moment capacity) due to the 2nd tunnel T. On the contrary, tunneling right underneath the toe of pile (i.e., Test G_SU) results in the smallest tilting but largest settlement of the pile group (4.6% of pile diameter) and incremental mobilisation of shaft resistance (13%). Due to stress release by the twin tunneling, the axial force taken by the front piles close to tunnels was reduced and partially transferred to the rear piles. This load transfer can increase the axial force in rear piles by 24%.

Keywords:

twin tunneling, pile group, three-dimensional, soil-structure interaction, centrifuge modeling

Downloads

Download data is not yet available.

References

C. H. Pang, K. Y. Yong, Y. K. Chow, “Three dimensional numerical simulation of tunnel advancement on adjacent pile foundation” Underground Space Use: Analysis of the Past and Lessons for the Future, pp. 1141–1147. London: Taylor and Francis, 2005

A. Bezuijen, J. S. van der Schrier, “The influence of a bored tunnel on pile foundations”, Centrifuge’94, Rotterdam, Netherlands. pp. 681-686, 1994

L. T. Chen, H. G. Poulos, N. Loganathan, “Pile responses caused by tunneling”, Journal of Geotechnical and Geoenvironmental Engineering, Vol. 125, No. 3, pp. 207-215, 1999 DOI: https://doi.org/10.1061/(ASCE)1090-0241(1999)125:3(207)

N. Loganathan, H .G. Poulos, D. P. Stewart, “Centrifuge model testing of tunneling-induced ground and pile deformations”, Geotechnique, Vol. 50, No.3, pp. 283-294, 2000 DOI: https://doi.org/10.1680/geot.2000.50.3.283

H. Mroueh, I. Shahrour, “Three-dimensional finite element analysis of the interaction between tunneling and pile foundations”, International Journal for Numerical and Analytical Methods in Geomechanics, Vol. 26, No. 3, pp. 217-230, 2002 DOI: https://doi.org/10.1002/nag.194

S. W. Jacobsz, J. R. Standing, R. J. Mair, T. Hahiwara, T. Suiyama, “Centrifuge modeling of tunneling near driven piles”, Soil and Foundations, Vol. 44, No. 1, pp. 49-56, 2004 DOI: https://doi.org/10.3208/sandf.44.49

C. Y. Cheng, G. R. Dasari, Y. K. Chow, C. F. Leung, “Finite element analysis of tunnel-soil-pile interaction using displacement controlled model”, Tunneling and Underground Space Technology, Vol. 22, No. 4, pp. 450–466, 2007 DOI: https://doi.org/10.1016/j.tust.2006.08.002

Y. J. Lee, Tunneling Adjacent to a Row of Loaded Piles, PhD Thesis, University College London, University of London, 2004

C. J. Lee, “Numerical analysis of the interface shear transfer mechanism of a single pile to tunneling in weathered residual soil” Computers and Geotechnics, Vol. 42, 193–203, 2012 DOI: https://doi.org/10.1016/j.compgeo.2012.01.009

P. Kitiyodom, T. Matsumoto, K. Kawaguchi, “A simplified analysis method for piled raft foundations subjected to ground movements induced by tunneling”, International Journal for Numerical and Analytical Methods in Geomechanics, Vol. 29, No. 15, pp. 1485–1507, 2005 DOI: https://doi.org/10.1002/nag.469

G. T. K. Lee, C. W. W. Ng, “The effects of advancing open face tunneling on an existing loaded pile”, Journal of Geotechnical and Geoenvironmental Engineering, Vol. 131, No. 2, pp. 193–201, 2005 DOI: https://doi.org/10.1061/(ASCE)1090-0241(2005)131:2(193)

C. J. Lee, S. W. Jacobsz, “The influence of tunneling on adjacent piled foundations”, Tunneling and Underground Space Technology, Vol. 21, No. 3-4, pp. 430, 2006 DOI: https://doi.org/10.1016/j.tust.2005.12.072

C. J. Lee, K. H. Chiang, “Responses of single piles to tunneling-induced soil movements in sandy ground”, Canadian Geotechnical Journal, Vol. 44, No.10, pp. 1224-1241, 2007 DOI: https://doi.org/10.1139/T07-050

M. Huang, C. Zhang, Z. Li, “A simplified analysis method for the influence of tunneling on grouped piles”, Tunneling and Underground Space Technology, Vol. 24, No. 4, pp. 410–422, 2009 DOI: https://doi.org/10.1016/j.tust.2008.11.005

S. W. Lee, C. K. M. Choy, W. W. L. Cheang, W. Swolfs, R. Brinkgreve, “Modeling of tunneling beneath a building supported by friction bored piles”, 7th Southeast Asian Geotechnical Conference, pp. 215–218, 2010

M. Devriendt, M. Williamson, “Validation of methods for assessing tunneling-induced settlements on piles”, Ground Engineering, pp.25–30, 2011

C. W. W. Ng, H. Lu, S. Y. Peng, “Three-dimensional centrifuge modeling of effects of twin tunneling on as existing pile”, Tunneling and Underground Space Technology, Vol. 35, pp. 189-199, 2013 DOI: https://doi.org/10.1016/j.tust.2012.07.008

C. W. W. Ng, H. Lu, “Effects of construction sequence of twin tunneling at different depth on a single pile”, Canadian Geotechnical Journal, Vol. 51, pp. 173-183, 2013 DOI: https://doi.org/10.1139/cgj-2012-0452

C. W. W. Ng, P. A. Van Laak, W. H. Tang, X. S. Li, L. M. Zhang, “The Hong Kong geotechnical centrifuge”, 3rd International Conference on Soft Soil Engineering, Hong Kong, pp. 225-230, 2001

C. W. W. Ng, P. A. Van Laak, L. M. Zhang, W. H. Tang, G. H. Zong, Z. L. Wang, G. M. Xu, S. H. Liu, “Development of a four-axis robotic manipulator for centrifuge modeling at HKUST”, International Conference on Physical Modeling in Geotechnics, St. John's Newfoundland, Canada, pp. 71-76, 2002

R. Rowe, G. Kack, “A theoretical examination of the settlements induced by tunneling: four case histories”, Canadian Geotechnical Journal, Vol. 20, No. 2, pp. 299–314, 1983 DOI: https://doi.org/10.1139/t83-033

A. M. Marshall, Tunneling in sand and its effect on pipelines and piles. PhD Thesis, Cambridge University, 2009

R. J. Mair, R. N. Taylor, A. Bracegirdle, “Subsurface settlement profiles above tunnels in clay”, Geotechnique, Vol. 43, No. 3, pp. 315-320, 1993 DOI: https://doi.org/10.1680/geot.1993.43.2.315

A. A. Balkema, “Bored tunneling in the urban environments”, 14th International Conference on Soil Mechanics and Foundation Engineering, Hamburg, Germany, Vol. 4, pp. 2353-2385, 1997

M. Uesugi, H. Kishida, “Tests of the interface between sand and steel in the simple shear apparatus”, Geotechnique, Vol. 37, No. 1, pp. 45-52, 1987 DOI: https://doi.org/10.1680/geot.1987.37.1.45

V. Fioravante, “On the shaft friction modeling of non-displacement piles in sand”, Soils and Foundations, Vol. 42, No.2, pp. 23-33, 2002 DOI: https://doi.org/10.3208/sandf.42.2_23

K. Ishihara, “Liquefaction and flow failure during earthquakes”, Geotechnique, Vol. 43, No. 3, pp. 351-415, 1993 DOI: https://doi.org/10.1680/geot.1993.43.3.351

L. D. Fuglsang, N. K. Ovesen, The theory of modeling to centrifuge studies, Centrifuge in soil mechanics, Craig, James and Schofield, Balkema, Rotterdam, 1988

C. W. W. Ng, T. L. Y. Yau, J. H. M. Li, W. H. Tang, “New failure load criterion for large diameter bored piles in weathered geomaterials”, Journal of Geotechnical and Geoenvironmental Engineering, Vol. 127, No. 6, pp. 488-498, 2001 DOI: https://doi.org/10.1061/(ASCE)1090-0241(2001)127:6(488)

D. Selemetas, The response of full-scale piles and pile structures to tunneling, PhD Thesis, Cambridge University, 2005 DOI: https://doi.org/10.1201/NOE0415391245.ch106

L. M. Zhang, A. M. Y. Ng, “Probabilistic limiting tolerable displacements for serviceability limit state design of foundations”, Geotechnique, Vol. 55, No. 2, pp. 151-161, 2005 DOI: https://doi.org/10.1680/geot.2005.55.2.151

CEN Eurocode 7 part 1, “Geotechnical design: General rules, Final Draft”, prEN 1997–1, Brussels: European Committeef or Standardization (CEN), 2001

Downloads

How to Cite

[1]
M. A. Soomro, M. A. Keerio, M. A. Soomro, and D. K. Bangwar, “3D Centrifuge Modeling of the Effect of Twin Tunneling to an Existing Pile Group”, Eng. Technol. Appl. Sci. Res., vol. 7, no. 5, pp. 2030–2040, Oct. 2017.

Metrics

Abstract Views: 905
PDF Downloads: 251

Metrics Information
Bookmark and Share

Most read articles by the same author(s)

<< < > >>