Study of Synergistic Effect of Silica Fume and Fly Ash Inclusion in High Performance Concrete

Authors

  • Manish Ranjan Department of Civil Engineering, National Institute of Technology Patna, India
  • Sanjay Kumar Department of Civil Engineering, National Institute of Technology Patna, India
  • Sanjeev Sinha Department of Civil Engineering, National Institute of Technology Patna, India
Volume: 14 | Issue: 5 | Pages: 16311-16316 | October 2024 | https://doi.org/10.48084/etasr.8071

Abstract

The use of Supplementary Cementitious Materials (SCMs) in the construction industry to reduce the carbon footprint associated with cement manufacturing is increasing worldwide. This study examined the synergistic behavior of two SCMs, Fly Ash (FA) and Silica Fume (SF), in the production of High-Performance Concrete (HPC). Using various amounts of SF and FA to replace cement, several ternary mixes were created and their strength, microstructure, durability and fresh state properties were evaluated.  A Rapid Chloride Permeability test (RCPT) was performed to determine the resistance of the mixture to chloride ion penetration. Microstructural analysis was carried out utilizing Scanning Electron Microscopy (SEM) images to study the morphological characteristics of the mixes. The results revealed that the combined use of SF and FA in HPC significantly increased its durability and compressive strength owing to the pozzolanic reaction and filler effect. Microstructural investigation exhibited improved particle packing, refined pore structure, and the creation of more Calcium Silicate Hydrate (CSH) phases. Thus, SF and FA, when used in conjugation, optimize HPC performance and promise to be a sustainable and viable solution for reducing cement requirements.

Keywords:

pozzolanic reaction, supplementary cementitious materials, silica fume, fly ash, microstructure

Downloads

Download data is not yet available.

References

K. L. Scrivener, V. M. John, and E. M. Gartner, "Eco-efficient cements: Potential economically viable solutions for a low-CO2 cement-based materials industry," Cement and Concrete Research, vol. 114, pp. 2–26, Dec. 2018.

S. Prakasan, S. Palaniappan, and R. Gettu, "Study of Energy Use and CO2 Emissions in the Manufacturing of Clinker and Cement," Journal of The Institution of Engineers (India): Series A, vol. 101, no. 1, pp. 221–232, Mar. 2020.

J. G. J. Olivier, G. Janssens-Maenhout, M. Muntean, and J. A. H. W. Peters, "Trends in global CO2 emissions; 2015 Report," The Hague: PBL Netherlands Environmental Assessment Agency; Ispra: European Commission, Joint Research Centre, 2015.

R. Snellings, "Assessing, Understanding and Unlocking Supplementary Cementitious Materials," RILEM Technical Letters, vol. 1, pp. 50–55, Aug. 2016.

E. C. Arvaniti et al., "Physical characterization methods for supplementary cementitious materials," Materials and Structures, vol. 48, no. 11, pp. 3675–3686, Nov. 2015.

J. Skibsted and R. Snellings, "Reactivity of supplementary cementitious materials (SCMs) in cement blends," Cement and Concrete Research, vol. 124, Oct. 2019, Art. no. 105799.

F. Tittarelli, A. Mobili, and T. Bellezze, "The Effect of Fly Ash on the Corrosion Behaviour of Galvanised Steel Rebarsin Concrete," IOP Conference Series: Materials Science and Engineering, vol. 225, no. 1, Aug. 2017, Art. no. 012107.

P. K. Mehta, "Pozzolanic and Cementitious by-Products in Concrete--Another Look," ACI Symposium Publication, vol. 114, pp. 1–44, May 1989.

N. De Belie, M. Soutsos, and E. Gruyaert, Eds., Properties of Fresh and Hardened Concrete Containing Supplementary Cementitious Materials, vol. 25. Cham: Springer International Publishing, 2018.

J.-R. Weng and W.-C. Liao, "Microstructure and shrinkage behavior of high-performance concrete containing supplementary cementitious materials," Construction and Building Materials, vol. 308, Nov. 2021, Art. no. 125045.

A. W. Khan and S. Kumar, "The Effect of Fly Ash and Silica Fume on the Rheology of Cement Slurries of Ordinary Portland Cement of Grade 43 and 53," Engineering, Technology & Applied Science Research, vol. 14, no. 4, pp. 14876–14881, Aug. 2024.

M. Cyr, P. Lawrence, and E. Ringot, "Mineral admixtures in mortars: Quantification of the physical effects of inert materials on short-term hydration," Cement and Concrete Research, vol. 35, no. 4, pp. 719–730, Apr. 2005.

W. A. Gutteridge and J. A. Dalziel, "Filler cement: The effect of the secondary component on the hydration of Portland cement: Part I. A fine non-hydraulic filler," Cement and Concrete Research, vol. 20, no. 5, pp. 778–782, Sep. 1990.

B. Lothenbach, K. Scrivener, and R. D. Hooton, "Supplementary cementitious materials," Cement and Concrete Research, vol. 41, no. 12, pp. 1244–1256, Dec. 2011.

S. von Greve-Dierfeld et al., "Understanding the carbonation of concrete with supplementary cementitious materials: a critical review by RILEM TC 281-CCC," Materials and Structures, vol. 53, no. 6, Oct. 2020, Art. no. 136.

R. Snellings, P. Suraneni, and J. Skibsted, "Future and emerging supplementary cementitious materials," Cement and Concrete Research, vol. 171, Sep. 2023, Art. no. 107199.

M. I. Khan and R. Siddique, "Utilization of silica fume in concrete: Review of durability properties," Resources, Conservation and Recycling, vol. 57, pp. 30–35, Dec. 2011.

Standard Specification for Coal Fly Ash and Raw or Calcined Natural Pozzolan for Use in Concrete. West Conshohocken, PA, USA: ASTM International, 2014.

IS 3812-1 (2033): Specification for Pulverized Fuel Ash, Part 1: For Use as Pozzolana in Cement, Cement Mortar and Concrete. New Delhi, India: Bureau of Indian Standards, 2013.

ASTM C618: Standard Specification for Coal Fly Ash and Raw or Calcined Natural Pozzolan for Use as a Mineral Admixture in Concrete. West Conshohocken, PA, USA: ASTM International, 2015.

P. Suraneni, L. Burris, C. R. Shearer, and R. D. Hooton, "ASTM C618 Fly Ash Specification: Comparison with Other Specifications, Shortcomings, and Solutions," Materials Journal, vol. 118, no. 1, pp. 157–167, Jan. 2021.

A. Bharat and S. Kumar, "Microstructural investigation of ternary blended high-performance concrete using supplementary cementitious materials," Innovative Infrastructure Solutions, vol. 9, no. 4, Mar. 2024, Art. no. 111.

IS 383 : 2016 - Coarse and Fine Aggregate for Concrete - Specification (Third Revision). New Delhi, India: Bureau of Indian Standards, 2016.

211.4R-08: Guide for Selecting Proportions for High-Strength Concrete Using Portland Cement and Other Cementitious Materials. USA: American Concrete Institute, 2008.

IS 10262: 2019- Concrete Mix Proportioning- Guidelines. New Delhi, India: Bureau of Indian Standards, 2019.

R. Bleszynski, R. D. Hooton, M. D. A. Thomas, and C. A. Rogers, "Durability of Ternary Blend Concrete with Silica Fume and Blast-Furnace Slag: Laboratory and Outdoor Exposure Site Studies," Materials Journal, vol. 99, no. 5, pp. 499–508, Sep. 2002.

M. I. Khan, C. J. Lynsdale, and P. Waldron, "Porosity and strength of PFA/SF/OPC ternary blended paste," Cement and Concrete Research, vol. 30, no. 8, pp. 1225–1229, Aug. 2000.

M. Sumer, "Compressive strength and sulfate resistance properties of concretes containing Class F and Class C fly ashes," Construction and Building Materials, vol. 34, pp. 531–536, Sep. 2012.

D. K. Nayak, P. P. Abhilash, R. Singh, R. Kumar, and V. Kumar, "Fly ash for sustainable construction: A review of fly ash concrete and its beneficial use case studies," Cleaner Materials, vol. 6, Dec. 2022, Art. no. 100143.

G. Li et al., "Fly Ash Application as Supplementary Cementitious Material: A Review," Materials, vol. 15, no. 7, Jan. 2022, Art. no. 2664.

Y. Lou, K. Khan, M. N. Amin, W. Ahmad, A. F. Deifalla, and A. Ahmad, "Performance characteristics of cementitious composites modified with silica fume: A systematic review," Case Studies in Construction Materials, vol. 18, Jul. 2023, Art. no. e01753.

ASTM C1202: Standard Test Method for Electrical Indication of Concrete’s Ability to Resist Chloride Ion Penetration. West Conshohocken, PA, USA: ASTM International, 2019.

B. Uzbas and A. C. Aydin, "Microstructural Analysis of Silica Fume Concrete with Scanning Electron Microscopy and X-Ray Diffraction," Engineering, Technology & Applied Science Research, vol. 10, no. 3, pp. 5845–5850, Jun. 2020.

P. K. Mehta and P. J. M. Monteiro, Concrete: Microstructure, Properties, and Materials, 4th ed. New York, NY, USA: McGraw-Hill Education, 2014.

Downloads

How to Cite

[1]
Ranjan, M., Kumar, S. and Sinha, S. 2024. Study of Synergistic Effect of Silica Fume and Fly Ash Inclusion in High Performance Concrete. Engineering, Technology & Applied Science Research. 14, 5 (Oct. 2024), 16311–16316. DOI:https://doi.org/10.48084/etasr.8071.

Metrics

Abstract Views: 81
PDF Downloads: 93

Metrics Information

Most read articles by the same author(s)