Realistic Determination of Live Loads on Various Reinforced Concrete Structures

Authors

  • Z. Soomro Department of Civil Engineering, Quaid-e-Awam University of Engineering, Science & Technology, Larkana, Pakistan
  • S. Khoso Department of Civil Engineering, Quaid e Awam University of Engineering Science and Technology, Sindh, Pakistan
  • T. Ali Department of Civil Engineering, Islamia University of Bahawalpur, Pakistan
  • S. A. Abbasi Civil Engineering Department, Quaid-e-Awam University of Engineering, Science & Technology, Larkana, Pakistan
  • A. A. Ansari Department of Civil Engineering, Faculty of Engineering, Science, Technology and Management, Ziauddin University, Pakistan
  • M. T. Naqash Department of Civil Engineering, Faculty of Engineering, Islamic University of Madinah, Saudi Arabia

Abstract

This paper presents various case studies of examined and calculated live loads on reinforced concrete structures. These case studies accumulated information and data of existing structures about their design live loads and acquired detailed drawings showing the reinforcement in their floor slab sections. The actual occupancy loads that act on the floor slabs were assessed, and the ultimate loads that an individual slab section should be able to support were calculated using the methods recommended by ACI, CP-114, CP-110, and the yield line theory. A reinforced concrete slab panel was also tested to check the validity of the theoretically predicted ultimate loads. The results were compared to find a safety margin and, if necessary, recommend lower live load outlines for cost reduction. The case studies showed that there is sufficient margin to reduce design live loads on the floor slabs of residential buildings, especially in multistory apartment blocks. Moreover, it was found that the live loads, especially on residential buildings, could be decreased to two-thirds of the code values without risking floor overloading.

Keywords:

Structures, Loads, Economy, Occupancy, Slab, Reinforcement, case study

Downloads

Download data is not yet available.

References

M. A. Memon, A. A. Ansari, and B. A. Memon, "A Review of Intensity of Live Loads on RCC Floor Slabs," Mehran University Research Journal of Engineering and Technology, vol. 15, no. 2, pp. 15–25, 1996.

M. Memon and A. A. Ansari, "A Study of Occupancy Loads in Residential and Public Buildings in Pakistan," A Study of Occupancy Loads in Residential and Public Buildings in Pakistan, vol. 17, no. 4, pp. 145–150, 1998.

M. T. Naqash, K. Mahmood, and S. Khoso, "An Overview on the Seismic Design of Braced Frames," American Journal of Civil Engineering, vol. 2, no. 2, pp. 41–47, Mar. 2014. DOI: https://doi.org/10.11648/j.ajce.20140202.15

S. Khoso, J. Raad, and A. Parvin, "Experimental Investigation on the Properties of Recycled Concrete Using Hybrid Fibers," Open Journal of Composite Materials, vol. 09, no. 02, Apr. 2019, Art. no. 91812. DOI: https://doi.org/10.4236/ojcm.2019.92009

S. A. Mangi et al., "A Review on Potential use of Coal Bottom Ash as a Supplementary Cementing Material in Sustainable Concrete Construction," International Journal of Integrated Engineering, vol. 10, no. 9, 2018.

S. A. Mangi, M. H. W. Ibrahim, S. H. Khahro, N. Jamaluddin, and S. Shahidan, "Development of Supplementary Cementitious Materials: A Systematic Review," International Journal of Advanced Science and Technology, vol. 29, no. 9, pp. 4682–4691, 2020.

Y. Almoosi and N. Oukaili, "The Response of a Highly Skewed Steel I-Girder Bridge with Different Cross-Frame Connections," Engineering, Technology & Applied Science Research, vol. 11, no. 4, pp. 7349–7357, Aug. 2021. DOI: https://doi.org/10.48084/etasr.4137

M. T. Naqash, G. D. Matteis, and A. D. Luca, "Seismic design of steel moment resisting frames-European versus American practice," NED University Journal of Engineering Research, Oct. 2012.

A. H. Bhutto, G. S. Bhurgri, S. Zardari, M. A. Zardari, B. A. Memon, and M. M. Babar, "Settlement Response of a Multi-Story Building," Engineering, Technology & Applied Science Research, vol. 10, no. 5, pp. 6220–6223, Oct. 2020. DOI: https://doi.org/10.48084/etasr.3757

A. Soltani, S. Khoso, M. A. Keerio, and A. Formisano, "Assessment of Physical and Mechanical Properties of Concrete Produced from Various Portland Cement Brands," Open Journal of Composite Materials, vol. 9, no. 4, Sep. 2019, Art. no. 95273.

M. H. Naqash, M. H. Aburamadan, O. Harireche, A. AlKassem, and Q. U. Farooq, "The Potential of Wind Energy and Design Implications on Wind Farms in Saudi Arabia," International Journal of Renewable Energy Development, vol. 10, no. 4, pp. 839–856, 2021. DOI: https://doi.org/10.14710/ijred.2021.38238

S. Khoso, M. A. Keerio, and A. A. Ansari, "Effects of Rice Husk Ash and Recycled Aggregates on Mechanical Properties of Concrete," International Journal of Scientific & Engineering Research, vol. 8, no. 3, pp. 1832–1835, Mar. 2017.

M. Jovanović and G. Radoičić, "A Human Crowd Effect Modelled by the Discrete-Time Fourier Series," Facta Universitatis, Series: Working and Living Environmental Protection, vol. 14, no. 2, pp. 139–148, Jan. 2018. DOI: https://doi.org/10.22190/FUWLEP1702139J

M. Naqash, "Study on the Fundamental Period of Vibration of Steel Moment Resisting Games," International Journal of Advanced Structures and Geotechnical Engineering, vol. 3, no. 1, pp. 2319–2324, Jan. 2014.

M. Oad, A. H. Buller, B. A. Memon, and N. A. Memon, "Impact of Long-Term Loading on Reinforced Concrete Beams Made with Partial Replacement of Coarse Aggregates with Recycled Aggregates from Old Concrete," Engineering, Technology & Applied Science Research, vol. 9, no. 1, pp. 3818–3821, Feb. 2019. DOI: https://doi.org/10.48084/etasr.2498

S. Khoso, K. J. Shahzaib, A. A. Aziz, and K. Z. Hussain, "Experimental investigation on the properties of cement concrete partially replaced by silica fume and fly ash," Journal of Applied Engineering Science, vol. 14, no. 3, pp. 345–350, 2016. DOI: https://doi.org/10.5937/jaes14-11116

S. Khoso, F. Wagan, J. Khan, N. Bhatti, and A. Ansari, "Qualitative analysis of baked clay bricks available in Larkana region, Pakistan," Architecture Civil Engineering Environment, vol. 7, no. 2, pp. 41–50, 2014.

M. T. Naqash, Q. U. Farooq, and O. Harireche, "Seismic Evaluation of Steel Moment Resisting Frames (MRFs)—Supported by Loose Granular Soil," Open Journal of Earthquake Research, vol. 8, no. 2, Mar. 2019, Art. no. 91464. DOI: https://doi.org/10.4236/ojer.2019.82003

S. A. A. Shah, M. A. A. Gul, T. Naqash, Z. Khan, and M. Rizwan, "Effects of Fiber Reinforcements on the Strength of Shotcrete," Civil Engineering and Architecture, vol. 9, no. 1, pp. 176–183, Jan. 2021. DOI: https://doi.org/10.13189/cea.2021.090115

American Concrete Institute (ACI), Building code requirements for structural concrete (ACI 318-14): an ACI standard and commentary on building code requerements for structural concrete (ACI 318R-14). Farmington Hills, MI, USA: American Concrete Institute, ACI, 2014.

"Structural Codes of Practice. CP 114 : The Structural Use of Reinforced Concrete in Buildings,", British Standards Institute, CP 114, 1965.

"Structural Codes of Practice. CP 110:1:1972 for the structural use of concrete. Part 1: Design, materials and workmanship," Britich Standards Institute, CP 110:1:1972, 1972.

M. T. Naqash and A. Alluqmani, "Codal Requirements Using Capacity Design Philosophy, and Their Applications in the Design of Steel Structures in Seismic Zones," Open Journal of Earthquake Research, vol. 7, no. 2, pp. 88–107, Mar. 2018. DOI: https://doi.org/10.4236/ojer.2018.72006

M. T. Naqash, "Codal Comparisons for the Seismic Resistance of Steel Moment Resisting Frames (MRF). Part A: Codes Approach," International Journal of Construction Engineering and Management, vol. 6, no. 6, pp. 254–263, 2017.

M. Umar, S. A. A. Shah, K. Shahzada, M. T. Naqash, and W. Ali, "Assessment of Seismic Capacity for Reinforced Concrete Frames with Perforated Unreinforced Brick Masonry Infill Wall," Civil Engineering Journal, vol. 6, no. 12, pp. 2397–2415, Dec. 2020. DOI: https://doi.org/10.28991/cej-2020-03091625

M. Mumtaz, J. Mendoza, A. S. Vosoughi, A. S. Unger, and V. K. Goel, "A Comparative Biomechanical Analysis of Various Rod Configurations Following Anterior Column Realignment and Pedicle Subtraction Osteotomy," Neurospine, vol. 18, no. 3, pp. 587–596, Sep. 2021. DOI: https://doi.org/10.14245/ns.2142450.225

M. T. Naqash, "Pushover Response of Multi Degree of Freedom Steel Frames," Civil Engineering Journal, vol. 6, pp. 86–97, Dec. 2020. DOI: https://doi.org/10.28991/cej-2020-SP(EMCE)-08

Downloads

How to Cite

[1]
Z. Soomro, S. Khoso, T. Ali, S. A. Abbasi, A. A. Ansari, and M. T. Naqash, “Realistic Determination of Live Loads on Various Reinforced Concrete Structures”, Eng. Technol. Appl. Sci. Res., vol. 12, no. 3, pp. 8506–8511, Jun. 2022.

Metrics

Abstract Views: 359
PDF Downloads: 213

Metrics Information
Bookmark and Share

Most read articles by the same author(s)

<< < 1 2