Transient Analysis of the Fuzzy Logic-based Speed Control of a Three-phase BLDC Motor

Authors

  • S. Raja Department of Electrical & Electronics Engineering, Sri Chandrasekharendra Saraswathi Viswa Mahavidyalaya, India
  • M. Rathinakumar Department of Electrical & Electronics Engineering, Sri Chandrasekharendra Saraswathi Viswa Mahavidyalaya, India
Volume: 13 | Issue: 1 | Pages: 9855-9860 | February 2023 | https://doi.org/10.48084/etasr.5419

Abstract

The energy-efficient motor is a vital requirement for modern industrial, automobile, and home appliance drives. Among the special machines, the Brushless DC Motors (BLDCMs) are more attractive to the application engineer because they offer high power-to-weight ratio, compact construction, do not require consistent maintenance, and have an efficiency margin of 85–90%. This study uses FPGA to create fuzzy logic-based speed control for a three-phase BLDCM with transient time domain characteristics. The fuzzy logic-based controller algorithm is implemented using the FPGA Xilinx Spartan board, which receives the actual speed from a position sensor located inside the BLDCM. It calculates the ratio of the duty cycle of the Pulse Width Modulation (PWM) pulse. It is triggered by the driver system of the BLDCM drive to attain the reference speed. The performance characteristics of a BLDC motor drive such as steady-state error, peak overshoot, speed drop under loaded conditions, and restoration time after loaded conditions were analyzed using MATLAB/Simulink 2014. The hardware configuration setup is validated by the suggested system's simulation response.

Keywords:

Brushless DC Motor (BLDCM), steady state error, peak overshoot, Pulse Width Modulation (PWM), fuzzy logic, transients, Field Programmable Gate Array (FPGA)

Downloads

Download data is not yet available.

References

A. Emadi, Handbook of Automotive Power Electronics and Motor Drives. Boca Raton, FL, USA: CRC Press, 2005.

C.-L. Huang and S.-C. Yang, "Torque Ripple Reduction for BLDC Permanent Magnet Motor Drive using DC-link Voltage and Current Modulation," in 2021 IEEE International Future Energy Electronics Conference (IFEEC), Taipei, Taiwan, Aug. 2021. DOI: https://doi.org/10.1109/IFEEC53238.2021.9661795

X. Wang et al., "Stray Flux-Based Rotation Angle Measurement for Bearing Fault Diagnosis in Variable-Speed BLDC Motors," IEEE Transactions on Energy Conversion, vol. 36, no. 4, pp. 3156–3166, Sep. 2021. DOI: https://doi.org/10.1109/TEC.2021.3079444

I. Elomary, A. Ahmed, and I. Lhassane, "Optimization Design of the BLDC Motor Using Backtracking Search Algorithm," International Review of Electrical Engineering (IREE), vol. 16, no. 2, pp. 167–173, Apr. 2021. DOI: https://doi.org/10.15866/iree.v16i2.17411

S. B. Ozturk, W. C. Alexander, and H. A. Toliyat, "Direct Torque Control of Four-Switch Brushless DC Motor With Non-Sinusoidal Back EMF," IEEE Transactions on Power Electronics, vol. 25, no. 2, pp. 263–271, Oct. 2010.

S. B. Ozturk, W. C. Alexander, and H. A. Toliyat, "Direct Torque Control of Four-Switch Brushless DC Motor With Non-Sinusoidal Back EMF," IEEE Transactions on Power Electronics, vol. 25, no. 2, pp. 263–271, Oct. 2010. DOI: https://doi.org/10.1109/TPEL.2009.2028888

M. Perotti and F. Fiori, "A Closed Loop Delay Compensation Technique to Mitigate the Common Mode Conducted Emissions of Bipolar PWM Switched Circuits," IEEE Transactions on Power Electronics, vol. 36, no. 5, pp. 5450–5459, Feb. 2021. DOI: https://doi.org/10.1109/TPEL.2020.3031349

M. Karthik et al., "Evaluation of electromagnetic intrusion in brushless DC motor drive for electric vehicle applications with manifestation of mitigating the electromagnetic interference," International Journal of Ambient Energy, Oct. 2020. DOI: https://doi.org/10.1080/01430750.2020.1839546

T. C. Siong, B. Ismail, S. F. Siraj, M. F. Mohammed, and M. F. N. Tajuddin, "Implementation of Fuzzy Logic controller for permanent magnet brushless DC motor drives," in 2010 IEEE International Conference on Power and Energy, Kuala Lumpur, Malaysia, Aug. 2010, pp. 462–467. DOI: https://doi.org/10.1109/PECON.2010.5697627

E. Monmasson and M. N. Cirstea, "FPGA Design Methodology for Industrial Control Systems—A Review," IEEE Transactions on Industrial Electronics, vol. 54, no. 4, pp. 1824–1842, Dec. 2007. DOI: https://doi.org/10.1109/TIE.2007.898281

S. Raja, D. M. Rathinakumar, and A. S. Viswanathan, "Performance Analysis of Digital Controller for BLDC Motor Drive System," International Journal of Innovative Research in Science, Engineering and Technology, vol. 6, no. 6, pp. 10825–10831, 2007.

V. G. K and J. D. Shree, "Implementation of a High Power Quality BLDC Motor Drive Using Bridgeless DC to DC Converter with Fuzzy Logic Controller," Engineering, Technology & Applied Science Research, vol. 12, no. 5, pp. 9178–9185, Oct. 2022. DOI: https://doi.org/10.48084/etasr.5213

D. B. Minh, V. D. Quoc, and P. N. Huy, "Efficiency Improvement of Permanent Magnet BLDC Motors for Electric Vehicles," Engineering, Technology & Applied Science Research, vol. 11, no. 5, pp. 7615–7618, Oct. 2021. DOI: https://doi.org/10.48084/etasr.4367

A. Prakash and C. Naveen, "Combined strategy for tuning sensor-less brushless DC motor using SEPIC converter to reduce torque ripple," ISA Transactions, Jul. 2022. DOI: https://doi.org/10.1016/j.isatra.2022.06.045

J.-W. Reu, J. Hur, B.-W. Kim, and G.-H. Kang, "Vibration reduction of IPM type BLDC motor using negative third harmonic elimination method of air-gap flux density," in 2010 IEEE Energy Conversion Congress and Exposition, Atlanta, GA, USA, Sep. 2010, pp. 1745–1752. DOI: https://doi.org/10.1109/ECCE.2010.5618125

M. Hussain, A. Ulasyar, H. S. Zad, A. Khattak, S. Nisar, and K. Imran, "Design and Analysis of a Dual Rotor Multiphase Brushless DC Motor for its Application in Electric Vehicles," Engineering, Technology & Applied Science Research, vol. 11, no. 6, pp. 7846–7852, Dec. 2021. DOI: https://doi.org/10.48084/etasr.4345

P. Ubare and D. N. Sonawane, "Performance Assessment of the BLDC Motor in EV Drives using Nonlinear Model Predictive Control," Engineering, Technology & Applied Science Research, vol. 12, no. 4, pp. 8901–8909, Aug. 2022. DOI: https://doi.org/10.48084/etasr.4976

R. O. Reddy, S. Kautish, V. P. Reddy, N. S. Yadav, M. M. Alanazi, and A. W. Mohamed, "Effects of Integrated Fuzzy Logic PID Controller on Satellite Antenna Tracking System," Computational Intelligence and Neuroscience, vol. 2022, Mar. 2022, Art. no. e7417298. DOI: https://doi.org/10.1155/2022/7417298

T. Muthamizhan, B. Shivaji, and M. Aijaz, "Fuzzy logic controller based Multilevel Inverters integrated Speed Control of Induction Motors," in 2022 3rd International Conference for Emerging Technology (INCET), Belgaum, India, Feb. 2022. DOI: https://doi.org/10.1109/INCET54531.2022.9824251

F. Belgacem, M. Mostefai, M. Yahia, and A. Belgacem, "Optimization of Photovoltaic Water Pumping System Based on BLDC Motor for Agricultural Irrigation with Different MPPT Methods," Periodica Polytechnica Electrical Engineering and Computer Science, vol. 66, no. 4, pp. 315–324, Oct. 2022. DOI: https://doi.org/10.3311/PPee.20140

Downloads

How to Cite

[1]
Raja, S. and Rathinakumar, M. 2023. Transient Analysis of the Fuzzy Logic-based Speed Control of a Three-phase BLDC Motor. Engineering, Technology & Applied Science Research. 13, 1 (Feb. 2023), 9855–9860. DOI:https://doi.org/10.48084/etasr.5419.

Metrics

Abstract Views: 534
PDF Downloads: 443

Metrics Information