Shrinkage of Concrete Panels Made with Recyclable Concrete Aggregates
An experimental study on the shrinkage of recyclable aggregate concrete panels is presented in this paper. Recyclable aggregates are used in 50%, 60%, 70% and 80% replacement of natural coarse aggregates. For each replacement percentage, 3 panels were cast using 1:2:4 mix with 0.54 water-cement ratio and were cured for 28 days. In addition, 3 panels with the same parameters but using all-natural coarse aggregates were also cast to compare the results. Shrinkage in all panels was recorded for 3 months. Comparison of results reveals that with a 50% replacement, 8.33% increase in shrinkage was recorded. Along with shrinkage, cracks were also observed. At the end of the three month period, the widest crack had less width than 1mm, showing good resistance of the proposed material to shrinkage. Concluding, 50% replacement can be used in new concrete.
Keywords:shrinkage, reinforced concrete panels, recyclable concrete aggregates, green concrete, concrete demolishing waste
B. A. Memon, “Recent Development on Use of Demolished Concrete as Coarse Aggregates”, International Journal of Emerging Technology and Innovative Engineering, Vol. 2, No. 1, pp. 1-11, 2016
M. Oad, A. H. Buller, B. A. Memon, N. A. Memon, “Flexural Stress-Strain Behavior of RC Beams Made with Partial Replacement of Coarse Aggregates with Coarse Aggregates from Old Concrete Part-1, Ratio 1:2:4”, Engineering, Technology & Applied Science Research, Vol. 8, No. 3, pp. 3048-3053, 2018 DOI: https://doi.org/10.48084/etasr.1982
M. Oad, A. H. Buller, B. A. Memon, N. A. Memon, “Flexural Stress-Strain Behavior of RC Beams Made with Partial Replacement of Coarse Aggregates with Coarse Aggregates from Old Concrete Part-2: 1:2:4 Ratio”, Engineering, Technology & Applied Science Research Engineering, Technology & Applied Science Research, Vol. 8, No. 5, pp. 3338-3343, 2018 DOI: https://doi.org/10.48084/etasr.2129
R. Singh, J. Singh, “Recycled Aggregate Concrete (RAC) – A Sustainable Approach for Construction Industry”, International Journal of Research in Engineering & Applied Sciences, Vol. 5, No. 11, pp. 60-65, 2015
R. V. Silva, J. de Brito, R. K. Dhir, “Prediction of the Shrinkage of Recycled Aggregate Concrete”, Construction and Building Materials, Vol. 77, pp. 327-339, 2015 DOI: https://doi.org/10.1016/j.conbuildmat.2014.12.102
Y. F. Yang, L. H. Han, X. Wu, “Concrete Shrinkage and Creep in Recycled Aggregate Concrete Filled Steel Tubes”, Advances in Structural Engineering, Vol. 11, No. 4, pp. 383-396, 2016 DOI: https://doi.org/10.1260/136943308785836772
M. Eckert, M. Oliveira, “Risk of Plastic Shrinkage Cracking in Recycled Aggregate Concrete”, International Journal of Civil and Environmental Engineering, Vol. 9, No. 7, pp. 931-937, 2015
M. A. Salau, E. E. Ikponmwosa, A. O. Adeemo, “Shrinkage Deformation of Concrete Containing Recycled Coarse Aggregate”, British Journal of Applied Science & Technology, Vol. 4, No. 12, pp. 1791-1807, 2014 DOI: https://doi.org/10.9734/BJAST/2014/3950
B. A. Whiting, T. J. McCarthy, E. Lume, “Drying Shrinkage of Concrete Made from Recycled Concrete Aggregate”, 22nd Australasian Conference on the Mechanics of Structures and Materials, Sydney, Australia, December 11-14, 2012 DOI: https://doi.org/10.1201/b15320-213
L. J. Zhu, “The Study on Early Drying Shrinkage of Recycled Aggregate Concrete”, 2nd International Conference on Waste Engineering and Management, Shanghai, China, October 13-15, 2010
M. West, D. Darwin, J. A. Browning, Effect of Materials and Curing Period on Shrinkage of Concrete, Structural Engineering and Engineering Materials, SM Report No. 98, University of Kansas, 2010
P. R. L. Lima, M. B. Leite, “Influence of CDW Recycled Aggregate on Drying Shrinkage of Mortar”, Open Journal of Civil Engineering, Vol. 2, No. 2, pp. 53-57, 2012 DOI: https://doi.org/10.4236/ojce.2012.22009
A. B. E. Cabral, V. Schalch, D. C. C. Dal-Molin, J. L. D. Riberio, R. S. Ravindrarjah, “Shrinkage Modeling for Recycled Aggregate Concretes”, IBRACON Structures and Materials Journal, Vol. 3, No. 1, pp. 1-23, 2010
A. Domnigo-Cabo, C. Lazaro, F. Lopez-Gayarre, M. A. Serrano-Lopez, P. Serna, J. O. Catano-Tabares, “Creep and Shrinkage of Recycled Aggregate Concrete”, Construction and Building Materials, Vol. 23, No. 7, pp. 2545-2553, 2009 DOI: https://doi.org/10.1016/j.conbuildmat.2009.02.018
M. Oad, B. A. Memon, “Compressive Strength of Concrete Cylinders using Coarse Aggregates from Old Concrete”, 1st National Conference on Civil Engineering (Modern Trends and Advancements), April 28-29, 2014
How to Cite
MetricsAbstract Views: 464
PDF Downloads: 274
Authors who publish with this journal agree to the following terms:
- Authors retain the copyright and grant the journal the right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) after its publication in ETASR with an acknowledgement of its initial publication in this journal.